General Instructions for Stove Accessories
WARNINGS for USE(Please refer to the Terms of purchased item)
Please read the following terms carefully and fully understand them before use.
Please keep this paper properly for the convenience of reading before each use.
■ Usage Demonstration
|
1. Fastfold Oven Please wear gloves for assembly to prevent possible injury. |
 |
|
WARNING: When cooking food in the oven, please control the temperature of the oven within the measurement range of the thermometer by adjusting the air inflow and the wood inside the firebox of the stove. WARNING: When the oven is not in use for cooking food, it is strictly prohibited to heat up the EMPTY oven on the stove to avoid the deformation of the oven or failure of the thermometer by high temperature. |
 |
| Assembly Instruction | 
|
Storage Status |
| Usage Demonstration | 
|
Use on the Wood Stove |
|
Use on the Gas Stove |
WARNING: It is not recommended to use this oven on a gas cooker for long time, which may shorten the service life of the bottom mesh. |
|
Use on the Firepit |
WARNING: It is recommended to place the oven on the firepit after the wood burns to charcoal to prevent smoke from the burning wood pouring into the oven. |
|
2. Pipe Oven Please wear gloves for assembly to prevent possible injury. The best installation position is between the 1st and the 2nd pipe sections. |
 |
|
WARNING: When cooking food in the oven, please control the temperature of the oven within the measurement range of the thermometer by adjusting the air inflow and the wood inside the firebox of the stove. WARNING: When the oven is used on the stove, pegs are the must to fix the stove legs to the ground to reinforce the stability and to avoid the risk of the stove toppling. WARNING: When the oven is not in use for cooking food, it is strongly recommended to remove the oven door to ensure sufficient heat dissipation inside the oven. WARNING: When meat or other greasy food is cooked, it is recommended to wrap it with tin foil to avoid the grease splashing to inner wall or door of the oven, which is hard to clean. |
Usage Demonstration |
|
3. Water Tank Please wear gloves for assembly to prevent possible injury. |
 |
|
WARNING: To heat an EMPTY Water Tank will get the water tank heavily deformed and get the spigot damaged, the water tank can't be used any longer. |
※Please control the water level below the handle holes. |
|
S-sized Water Tank |
M/L-sized Water Tank |
Usage Demonstration ※No side or rear hooks on all Woodlander stoves or on Nomad plus external air intake stoves. |
FOR FIRST TIME USE OF THE WATER TANK
Step 1: Rinse the water tank thoroughly with mild detergent and water.
Step 2: Fill the water tank with fresh water to the position underneath the handle holes.
Step 3: Boil the water and then discard the water by flowing out through the spigot.
Step 4: Repeat steps 2 and 3 for 2-3 times.
Step 5: Start using the water tank.
|
4. Flashing Kit Heat Protector Chimney Please wear gloves for assembly to prevent possible injury. |
|
 |
|
Flashing Kit must be installed at the position below the 5th row of the holes of the Heat Protector Chimney. If there’s an installation angle, please must make sure that any position of the Silicone part of the Flashing Kit must below the 5th row of these holes as well. We recommend to purchase Winnerwell® Short Pipes separately for height adjustment to meet the above specified position requirement. WARNING: Temperature at the top part of the Heat Protector Chimney is high, the Silicone part must avoid the position of the upper cooling holes. WARNING: If to use the Heat Protector Chimney at the position of pipe exit on the tent, please must make sure that the minimum clearance from the top surface of the stove to combustible materials is 1500mm (60in), please refer to the details described in the Stove Instruction Manuals. |
Usage Demonstration |
|
5. Mesh Protector Please wear gloves for assembly to prevent possible injury. |
 |
| This Mesh Protector can be installed at any position outside of the standard pipe to prevent the risk of accidental scalds by the hot pipe. |
Usage Demonstration |
