Instruction Manual
Winnerwell® Titanium Heat Protector for M/L nested pipe
 |
◎ Material: Titanium ◎ Stowed Dimension: 150(L)mm×90(W)mm×400(H)mm/5.9(L)in×3.5(W)in×15.7(H)in ◎ Assembly Diameter: 150mm / 5.9in ◎ Assembly Length: 400mm / 15.7in ◎ Net Weight: Approx. 0.34kg / 0.75lbs |
■ Assembly Instruction
| 1. Part Details |
Heat Shield×1 |
Support Clamp×2 |
| 2. Remove the bolts from all parts |
|
7 in total |
| 3. Screw the bolt to the heat shield | 
|
| 4. Assemble the support clamps |  |
 |
5. Put the nested pipe(s) into the heat protector, adjust to your intended height and tighten the wing bolts on both ends to lock the connection.
 |
 |
 |
Tighten the wing bolt(s) |
| 6. Usage Demonstration |  |
| It is recommended to use two Titanium Heat Protectors at a time when the angle between the protector and the tent/shelter is less than 30 degrees. |  |