Instruction Manual

Winnerwell® Titanium Heat Protector for rolled pipe

◎ SKU: 910381 ◎ Name: Winnerwell® Titanium Heat Protector for rolled pipe ◎ Assembly Length: 300mm / 11.8 in ◎ Net Weight: Approx. 0.15kg / 0.33lbs ◎ Material: T=0.1mm Titanium

1. Check before assembly To check if there are missing, damaged or abnormal parts. Remember to  wear gloves when assembling to prevent injury.

Heat Shield×1

Fixing Plate×2

2. Locking Adjustment Tab Instructions ※ Do not bend the fixing tab frequently to avoid cracking the part.

● As shown in the figure below, bend the fixing tab downward to a 90° angle.

● Rotate the locking adjustment tab to insert the fixing tab into the outer/inner hole. Flip it over and bend the fixing tab from the bottom to secure it in place, preventing the locking adjustment tab from rotating.

● Repeat the same procedure for all four locking adjustment tabs.

※ For use with the Winnerwell® Fastfold Titanium Stove SKU 910214, insert the fixing tab into the outer hole of the fixing plate.  For use with the Winnerwell® Fastfold Ultralight Titanium Stove SKU 910245, insert the fixing tab into the inner hole of the plate.

3. Assembly Instructions

Adjustable by sliding up and down
	Installation Complete

※ It is recommended to use two Titanium Heat Protectors at a time when the angle between the protector and the tent/shelter is less than 30 degrees.