manual-fastfold-titanium-camping-stove

For Outdoor Recreational Use Only

General Instruction Manual for Winnerwell® Fastfold Titanium wood burning camping stoves.

■ Applicable Models

Winnerwell® Fastfold PLUS Titanium
Nested Pipe Camping Stove S/M/L

Winnerwell® Fastfold Ultralight
Backpack Titanium Camping Stove

Winnerwell® Fastfold Titanium
Camping Stove S/M/L

■ Assembly Instructions

Winnerwell® Fastfold PLUS Titanium Nested Pipe Camping Stove Part Details

Stove Body×1

Top Cover×1

Nested Pipe×5 Nested Pipe×6

Guyline Fixing Ring×1

Spark Arrestor×1

Titanium Peg×2

Pipe Container Bag×1

Container Bag×1

Winnerwell® Fastfold Ultralight Backpack Titanium Camping Stove Part Details

Stove Body×1

Top Cover×1

Rolled Pipe×1

Pipe Ring×8

Spark Arrestor×1

Titanium Peg×2

Pipe Container Bag×1

Container Bag×1

Winnerwell® Fastfold Titanium Camping Stove Part Details

Stove Body×1

Top Cover×1

Rolled Pipe×1

Pipe Ring×8

Spark Arrestor×1

Container Bag×1

1. Check before assembly

※ To check if there are missing, damaged or abnormal parts.

※ Always remember to wear gloves when assembling to prevent injury.

2. Assemble the stove body

Fully unfold the two legs.
Erect all the side panels to a vertical position and rotate the fasteners (riveted on both sides) to secure the side panels in place.
Fix the stove with pegs after selecting a location.

3. Assemble the top cover

Place the cover panel on top (pipe opening faces backwards), rotate the fasteners to secure the cover panel.

For Nested Pipe (L-sized as example)

⊙ Stowed status of the Nested Pipes

1. Take out all the parts from the nested cylindar

2. Install the pipes

Install the pipes from top to bottom by the numbers marked on the pipes

Pipe sequence demo

4. Install the spark arrestor at the top

Install the spark arrestor with guy lines (sold separately) on #6 pipe section, insert #1 pipe section into the stove chimney base.

5. Fix the guy lines

Fix the guy lines attached to the spark arrestor on the ground.

For Rolled Pipe

1. Install the pipe

※ Wrinkles and creases are formed when the chimney pipe assembled, please note it will not affect the normal use.

Take out the pipe and unfold the pipe to flat.

Start on one end, carefully roll the pipe length ways into an elongated cone shape until you can slip the first pipe ring on. Move the ring down the pipe slowly and add more rings as you go to secure the pipe.

2. Install the spark arrestor at the top

After rolling the pipe, install the spark arrestor with guy lines (sold separately) on one end of the pipe, insert the other end into the stove chimney base.

3. Fix the guy lines

Fix the guy lines attached to the spark arrestor on the ground.

■ DANGER

1. DANGER: The stove is forbidden to use in air-tight environment, possible spillage of carbon monoxide will be life-threatening.
2. DANGER: Winnerwell® wood burning camping stoves are designed for outdoor recreational use only, which are not intended for use in residential dwellings.
3. DANGER: Clearances To Combustible Materials- Minimum clearance from the top surface of the stove to combustible materials is 1500mm(60in). Minimum clearances from the sides, rear and corner of the stove body to the combustible materials are 1200mm(48in). Minimum clearance from the fueling and ash removal side of the stove to the combustible materials is 1200mm(48in).
4. DANGER: Always ensure you have fireproof material underneath the stove, Winnerwell® Fireproof Mat is recommended. The mat must normally extend not less than 450mm(18in) in front of the loading door and 200mm(8in) beyond the other sides and back.
5. DANGER: Minimum Chimney Height Above the Roof of the Tent or Shelter-The top of the stove chimney should be high enough to be above the air turbulence caused when wind blows against the tent/shelter and its roof. The chimney must extend at least 1m(3ft) above the highest point of contact with the roof, and at least 60cm(2ft) higher than any roof line or obstacle within a horizontal distance of 3m(10ft).
6. DANGER: To start your fire, ensure the tent or shelter is well ventilated in the event of smoke spillage into the tent or shelter. When use this stove in a camping tent, always leave a window cracked or door opened. Ensure a minimum opening of 0.5m²(775 square inches) for adequate ventilation.
7. DANGER: Keep the damper on the chimney base in a fully open position when use the stove in a tent. To turn down or to close the damper may cause possible smoke spillage and therefore cause the spillage of carbon monoxide, which will be life-threatening(Not applicable to Fastfold Titanium Ultralight Camping Stove as there's no damper on this stove).
8. DANGER: This stove cannot be used in a camping tent at night unattended.
9. DANGER: Must use a monoxide detector if you use the stove in a tent or shelter! Please use dry wood only! The use of damp wood or other fuels may cause incomplete combustion and produce carbon monoxide.
10. DANGER: Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, ethyl alcohol or similar liquids to start or “reignite” a fire in the stove. Keep all such liquids well away from the stove while it is in use.
11. DANGER: Do not insert the stove pipe directly through the tent fabric. Winnerwell® Titanium Heat Protector must be used. Failure to adhere to these precautions could result in your tent catching fire.
12. DANGER: Check the spark arrestor and stove nested pipe sections/rolled pipe daily for excessive creosote build-up and clean daily to prevent clogging and to reduce the risk of chimney fire.
13. DANGER: Never build an excessive fire, use firewood full of pitch, or burn coal in the stove. This can create excessive heat, turn the stove cherry red, and potentially warp and damage the stove.
14. DANGER: Do not burn red the stove body or the chimney pipe. If the stove body or the chimney pipe turns red, please reduce the wood inside the firebox immediately to lower the temperature of the stove, otherwise it will be easy to cause a fire and the stove will deform heavily after cooling off.
15. DANGER: Never splash the stove during and after use; otherwise an irreversible deformation may arise, and a significant steam may escape out to incur scalding.
16. DANGER: Never attempt to move the stove or pipe sections while the stove is burning. Always ensure the stove has fully cooled before moving.
17. DANGER: Always wear heat resistant gloves or leather gloves when feeding wood into the stove, or adjusting dampers. It is strongly recommended to keep a fire extinguisher nearby in the event of an accident.
18. DANGER: When installing the Spark Arrestor, please attach guy lines to keep your flue pipe stable in high winds. Windy conditions may cause the stove pipe to shake and move, which may create an unsafe situation. Consider additional guy lines on your tent in high winds to maintain stability and to ensure the safe use of the stove.
19. DANGER: Never leave the stove burning unattended.
20. DANGER: Not intended for use by children under 16 years of age.
21. DANGER: The stove has on optimal temperature range between 400℉ and 700℉. Managing the stove to burn within this range is strongly recommended as low temperature may cause incomplete combustion while excessively high temperature may damage the stove. When start a fire, the temperature is very low, please keep the doors and windows of the tent or shelter fully opened to ensure a full ventilation. When it reaches the optimal temperature, keep the minimum opening for ventilation in accordance with the DANGER 6

■ WARNING

1. WARNING: Stove components may have sharp edges or corners, be sure to handle them with care to prevent injury.
2. WARNING: Remember to open the stove door slowly with the airvent wide open to reduce smoke spillage.
3. WARNING: Winnerwell® stoves can become extremely hot when in use. Special caution should be used when young children and pets are present to prevent unintentional contact with a hot stove.
4. WARNING: To prevent the unsafe situation of pipe shaking in windy conditions or the accidental toppling of the stove, it is necessary to use Winnerwell® Guyline Peg Set to fix the pipe system and to fix the legs of the stove to maintain the stability of the stove.